Search Results

The author considers the effects of velocity variation on the operation of a car and states that this variation is absorbed mainly by the flywheel. A formula is given for calculating the pressure on universal bearings. Various methods of protecting and lubricating joints are described. A number of European types of joints are illustrated. A much larger number of types of joints are used abroad in-asmuch as each maker usually makes his own design instead of purchasing it from a specialist as is the usual practice in this country. In conclusion the paper describes types of joints using flexible material, such as leather or spring steel.

The author outlines in a general way the relation of car performance to modern engine development. He considers particularly weight reduction and torque performance of high-speed engines, giving the undesirable characteristics attending the increased torque range gained by higher speed. He next discusses the relation of torque to total car weight, to acceleration and to hill-climbing ability and suggests a method of determining the value of a car in terms of its performance ability. The author holds incorrect those systems in which the amount of lubrication is in proportion to speed only; and in which oil for crankshaft and crankpin bearings must cool as well as lubricate them. He shows a system designed to solve these oiling problems. Static, running and distortion balance of a rotating mass are defined by the author, who shows how they apply to a large number of types of crankshafts.

The author gives a brief review of developments during the past year in the construction of aeroplanes, particularly as affected by the European War. He takes as an example the Renault twelve-cylinder engine, citing the respects in which the present differs from previous models. Such factors as the changes in cooling systems, method of drive, valve construction and starting devices are considered. The requirements of aeroplane engines, such as constant service, high speeds (of aeroplanes) and stream-line form of engines and radiators, are outlined. Propeller requirements are dealt with at length, curves being given by which the efficiency and diameter of the propeller can be obtained. In conclusion a number of different engine installations are illustrated and compared.

In this paper the author gives the results of an investigation of coarse crystallization. This investigation was carried out with commercial materials such as cold-drawn wire, hot and cold-rolled sheet, strip steel, cold-drawn tube and cold-pressings. The results of other investigations are briefly outlined. Coarse crystallization, or grain-growth, it is stated, is due to the action of a limited amount of strain, exceeding the elastic limit, followed by annealing within certain temperature ranges. The experimental work which led to this conclusion is explained in detail in the paper. The effect of forging, cold-drawing, cold-rolling and cold-pressing was determined with commercial materials. Some study was made of the effect of carbon on grain-growth and of the effect of coarse crystallization on the physical properties. In the discussion of commercial materials special reference is made to those used in motor car construction.

The author has selected fourteen automobiles on which to make a study of the factors of safety used in their design. He considers specifically the front axles, front-wheel spindles, propeller-shafts, clutch-shafts, transmission drive-shafts and rear-axle drive-shafts. The method of calculating the stresses is outlined; compositions of the steels used are given; and complete data are presented showing the factors of safety of the various parts, together with the intermediate figures used in obtaining the factors.

The question of the selection of the proper sizes of ball-bearings for any given set of conditions is one that should properly receive the consideration of those most expert in their design and application. However, in change speed gear design, where the ratio between the diameters of the bearings and the diameters of the gears is small, the sizes of the bearings have so great an influence on the center distance of the shafts and the shape and outline of the casing that a change in the bearings from those originally laid out frequently necessitates the redesigning of the whole job.